Loading... Please wait...

Our Newsletter


How to identify film contamination.

Water Break Test

 

 

1. To know if your drinking glasses are contaminated with a non-rinsing film select a random sample of glassware weekly (about 10 glasses).

2. Carry out the WATER BREAK TEST as shown below. If two or more glasses are contaminated (or overall 20% plus film), consider removing film using Proton Renovate®

 

dig-2.jpg

dig-3.jpg

 

 

1. Film is so smooth that liquid cannot get a grip on the glass surface as it were, it breaks and forms drops. In such a glass stout, beer, lager will not adhere to the inside of the glass, and the head will not cling. With a filmed lager glass the etch in the base will not be sharp and break out the gas and so the head will not be fully fed and the drink will not look as lively as it could.

2. Depending on the glasses' recent history film may be slight or cover the entire inside area, it may be only on the inside lip area as a result perhaps of detergent/rinse aid draining and drying in this area. Whatever the extent of the film on any particular glass, make a judgement about the overall amount of film on the sample as a whole. While zero film is to be aimed for, in practical circumstances around 20% total sample film indicates remedial action is a good idea.

3. Film can arise from a variety of sources. New glasses can carry a mould release film. Normally film arises as a result of contamination from (a) detergent/rinse aid overdose/underdose or incorrect chemical selection, (b) glasswasher wash/rinse problems, (c) excess waste protein in wash water.

4. See the Water Break Test as A practical in-house quality control tool and allocate this weekly job to one person.