
How to Stay Film Free
Glasswasher Maintenance Care
Glasswash Machine General Cleaning Instructions
Daily Tasks
-
Clean filters, (top main square filter if fitted, and tank filter).
-
Clean wash jets (large jets) located on top and bottom wash arms or bars.
-
Ensure wash tank is free from pips, cloves, bits of glass etc. and clean.
-
Ensure wash bar rotates freely, if not, remove and clean under centre bearing.
-
Ensure Detergent/Protobrite Ultra and Rinse Aid/Krystal Klear Ultra (if used) is available.
-
Pre treat glasses with Quash lipstick/soil remover prior to washing.
Weekly tasks (or after an occasional session when machine is not in daily use)
-
Ensure rinse bars rotate freely.
-
Clean rinse jets on top and bottom bars (small jets), if necessary.
-
Clean machine by adding one scoop of Renovate to wash water, and operate machine through four wash cycles, drain.
-
Wipe tank clean and brush clean door recesses.
-
Check levels of detergent and rinse aid.
Monthly Glassware Refurbishment
-
Restore glasses by adding three scoops of Renovate powder to the wash water.
-
Insert a basket of glasses and complete two wash cycles.
-
Remove basket and rinse glasses thoroughly without any delay.
-
Top up with one scoop after every four baskets washed.
This procedure removes film or stain from glasses ensuring good head retention, and also restores gas break-out in lager glasses by removing film from the bottom etching.
​
If your water is hard/limey use Profos de-scaler weekly to remove limescale from the wash tank and wash system.
​
**In addition comply with particular machine manufacturers maintenance and cleaning instructions.